Controllers already in the field
REC designs and manufactures the controllers in premium pellet grills from Blaz’n Grill Works and Pitts & Spitts. Each one holds a cook temperature with PID control, watches meat probes with automatic shutoff, and connects over Wi-Fi to iOS and Android apps, with firmware updates delivered over the air.
Pitts & Spitts
The Maverick 850 pellet grill, run by an REC controller.
Blaz’n Grill Works
The Grand Slam pellet grill, run by an REC controller.

Inside the controller
A pellet grill controller board: Wi-Fi module, triac outputs and power supply on one board, designed and built by REC.
Where it fits
The controllers above run pellet grills. The same building blocks carry over to any product that has to hold a temperature.
Cooking and food equipment
Pellet grills, smokers, ovens, warmers and holding cabinets, where food has to reach a temperature and stay there.
Industrial and process heat
Heaters, kilns, curing ovens, heat sealers and process equipment that need a setpoint held under load.
Lab and test equipment
Baths, incubators, test chambers and other instruments where a few degrees of overshoot spoils the result.
What we design
One team owns the whole controller, so the hardware, the firmware and the app agree with each other.
Sensing
Thermocouple, RTD and thermistor inputs with the conditioning, calibration and fault detection a real product needs: an open or shorted probe is caught, not read as a temperature.
Control
PID tuned to your heater and your thermal mass, with startup and shutdown sequences, and more than one probe where the product calls for it.
Power outputs
SSR, triac, relay and motor drives for heating elements, augers, fans and blowers, sized and protected for the load they switch.
Safety
Over-temperature cutoffs and fault shutdowns that work independently of the control loop, so a stuck output or a bad probe fails safe.
Connectivity
Wi-Fi and Bluetooth, companion apps, cloud monitoring and over-the-air firmware updates, so a fix reaches units already in the field.
Display and controls
Displays, buttons, encoders and touch screens, designed together with the firmware so the product feels like one thing.
Built and tested in Roanoke
SMT and automated through-hole assembly, conformal coating for boards that live near heat and moisture, and 100% electrical testing on every board with custom test fixtures for production runs. Details are on the PCB assembly page.
Common questions
Can you design a PID controller into our product?
Why not use an off-the-shelf panel controller?
PID or on/off for a heating element?
Have you shipped temperature controllers before?
What volumes do you build?
Will you sign an NDA before we share details?
Tell us what your product heats
The heater, the sensors, the temperature range and the quantities you need. An engineer will get back to you within one business day.
